PROJECT

Zigbee and Thread for connected homes and IoT: modules, gateways and sensors

Zigbee modules, gateways and Thread boards: how to choose the radio layer, the hub and the link to the cloud, with the Atlas catalogue references.

Zigbee and Thread: two mesh networks

Zigbee and Thread are two low-power wireless protocols designed for sensors and actuators that relay messages for one another. The CC2530 and E18-2G4Z27SI modules from Ebyte are presented as Zigbee modules. The DSM-042 from Dusun IoT is built on an EFR32MG21 chip, and the DFR1055 board from DFRobot, based on an ESP32-C6, mentions both Zigbee and Thread. The choice depends on the ecosystem you target: check the stack version and the supported application profile in the documentation.

Modules to integrate on your board

A module is fitted onto your printed circuit. The E18-MS1PA2-IPX and E18-MS1PA2-PCB from Ebyte differ by their antenna: an IPEX interface for the first, a PCB antenna for the second. The DSM-04B from Dusun IoT is presented as a Zigbee, Matter and BLE module. For a prototype, the DFR1055 board lets you try a network stack without designing a circuit. In every case, the antenna must follow the manufacturer’s recommendations.

Gateways and hubs towards the cloud

A gateway collects sensor messages and forwards them to the cloud or to the local network. The DSGW-030-1 and DSGW-210-D-12 from Dusun IoT are presented as Zigbee and Wi-Fi hubs. The DSGW-090-3 adds Thread and an LTE Cat1 connection, whereas the DSGW-081-3 links Zigbee sensors to a Modbus RS485 bus. Choose according to the uplink available on your site: Ethernet, Wi-Fi or cellular.

Zigbee sensors to pair with a gateway

The MIR-TE100 measures temperature and humidity, the MIR-WA100 detects water leaks and the MIR-MC100 monitors a door or window contact. These sensors work with a gateway that supports the same Zigbee version. Check this compatibility in the hub datasheet before buying several sensors.

What to verify before the quotation

Note the protocol version, the frequency band allowed in your region, the indoor range stated, the number of nodes per gateway and the firmware update method. For a Thread network, also specify the border router. These elements determine the number of gateways and the choice of modules.

How Atlas prepares your quotation

Describe the number of sensors, the areas to cover, the gateway you have in mind and the supervision system. Atlas Electronics gathers the matching catalogue references and quotes the full list on quotation. Your team then validates each datasheet before commissioning.

Frequently asked questions

Zigbee or Thread: which one should I choose?

Zigbee is widely used in home and building sensors. Thread is an IP-based mesh network, often combined with Matter. The choice depends on the ecosystem of your devices and on the hub you use; check compatibility in each product datasheet.

Is one gateway needed for each sensor?

No, a gateway connects several nodes. The exact number depends on the hub datasheet, on the range and on the obstacles of the site, and should be confirmed before installation.

How do I request a quotation?

Send us the list of sensors, the gateway you have in mind and the supervision architecture. Atlas Electronics quotes the full list on quotation.

Products mentioned

A project? Our engineers build the solution with you.

Send your requirements: Atlas proposes the architecture, the bill of materials and a quotation, then follows the supply.

Request a quotation