DFR1015 – Multi-output DC-DC buck converter 3.3V/5V/9V/12V

Multi-output DC-DC buck converter 3.3V/5V/9V/12V

Non-Isolated DC/DC Converters

  • 30mV
Manufacturer part number
DFR1015
Manufacturer
DFRobot
Low Ripple
30mV

Non-isolated DC-DC buck converter that steps a 7.5V to 30V input down to a selectable 3.3V, 5V, 9V or 12V output, for powering LEDs, robots, servos and small motors.

Product overview

DFRobot DFR1015 DC-DC buck converter. This non-isolated DC-DC buck converter from DFRobot steps an input voltage of 7.5V to 30V down to one selectable output of 3.3V, 5V, 9V or 12V, with the output preset to 5V.

Voltage selection. The output is chosen with the solder pads on the back of the module. The 5V pad is bridged at the factory; for another voltage, remove this bridge and bridge the pad of the desired voltage. Only one output voltage is available at a time.

Current ratings. With suitable heat dissipation, the maximum output current reaches 5A at 3.3V and 5V and 3.5A at 9V and 12V. Rated outputs without heat dissipation are 3A at 3.3V, 5V and 12V, and 2.5A at 9V, measured at 25 ℃. Continuous large-current loads require a heat sink.

Protection and status. The module includes 70℃ over-temperature protection and overload protection. An onboard indicator stays solid red during normal operation; when protection is triggered, the indicator goes out and the output voltage drops to 0.1V.

Low ripple. Output ripple is 30mV, useful when powering sensitive loads.

Size and integration. The module measures 2.7 cm by 2 cm (1.06 by 0.79 inches). The 2.54mm soldering-hole pitch accepts pin headers. This footprint suits compact builds where space around the power supply is limited.

Typical uses. Powering LEDs, robots, servos and small motors from a supply voltage higher than the desired output. Available on quotation from Atlas Electronics.

See all specifications

Highlights

  • Dimension: 2.7cm*2cm(length*width)/1.06*0.79"
  • Input Voltage: 7.5V~30V (24V below is recommended)
  • Low Ripple: 30mV
  • Soldering Hole Pitch: 2.54mm (can solder pin headers)

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote