SEN0325 – 6+1 MEMS Digital Microphone Array with I2S Output and RGB LED Ring

6+1 MEMS Digital Microphone Array with I2S Output and RGB LED Ring

Educational STEM Coding & Sensor Starter Packs

Manufacturer part number
SEN0325
Manufacturer
DFRobot

A six-plus-one digital MEMS microphone array with I2S output and a 12-LED RGB ring, designed for noise and echo reduction and for locating sound sources.

Product overview

DFRobot SEN0325. This DFRobot module is a 6+1 digital MEMS microphone array built from MSM261S4030H0 microphones with a 12-LED RGB ring, designed for multichannel audio capture and sound source localization.

Audio characteristics. Each MSM261S4030H0 microphone is omnidirectional, bottom ported and has an I2S digital output. Sound pressure level is 140 dB SPL, sensitivity is -26 dBFS at 1 kHz (1 Pa) and the signal to noise ratio is 57 dB over a 20 kHz A-weighted bandwidth.

Output interface. The output is digital I2S, with a built-in 24-bit audio port. The raw digital signal is sent directly to the microcontroller or DSP, without an additional codec.

LED ring. Twelve LEDs form a ring with a 120-degree viewing angle. They offer 256 colour levels and 32 brightness levels, at 20 mA per colour. The module supports positive or negative RGB output selection and two-lane synchronization.

Connectors and power. The module provides a 2×5-pin 2.54 mm header and a 10-pin 0.5 mm FPC connector. It operates at 3.3 V ±0.2 V DC, with an input current above 750 mA at full brightness. Dimensions are 78.1 × 88.8 mm.

Operating conditions. The operating temperature range is -30 °C to 85 °C.

Integration. Suited to embedded projects and portable devices that need digital audio capture and visual feedback. This product is available on quotation from Atlas Electronics.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote