Limited record: this part has neither specifications nor a datasheet in the catalog yet. It is shown for reference and is not indexed.

SEN0376 – Electrochemical alcohol gas sensor 0-5 ppm I2C and UART

Electrochemical alcohol gas sensor 0-5 ppm I2C and UART

Educational STEM Coding & Sensor Starter Packs

Manufacturer part number
SEN0376
Manufacturer
DFRobot

Factory-calibrated electrochemical alcohol sensor compatible with Arduino, measuring alcohol concentration in air over a 0 to 5 ppm range. Suited to detecting low alcohol concentrations.

Product overview

SEN0376 alcohol gas sensor. The SEN0376 is an Arduino-compatible electrochemical alcohol gas sensor module from DFRobot, measuring alcohol concentration in air. The module is factory calibrated and is stated to offer high stability, strong anti-interference and a service life of more than 2 years in air.

Measurement performance. The measuring range is 0 to 5 ppm with a resolution of 0.01 ppm or better (10 ppb). Preheat time is 3 min or less, and response and recovery times are each 60 s or less. The listed interfering gases are benzene (C6H6), toluene (C7H8), acetic acid (CH3COOH), hydrogen sulfide (H2S) and carbon monoxide (CO).

Interfaces and connectivity. The signal is available as I2C and UART (0 to 3 V), with the Gravity interface and a 4-pin I2C cable included.

Power and environment. The operating voltage is 3.3 to 5.5 V DC, with a power consumption of 0.05 W at 5 V. Operating temperature is -20 to 50 ℃, operating humidity 15 to 90 %RH without condensation, and storage temperature 0 to 25 ℃. The board measures 27 mm × 37 mm.

Typical uses. The sensor suits measuring low alcohol concentrations, for example in breathalyzers or smart vehicles, and prototyping an alcohol concentration detector with controllers such as Arduino, ESP32 or Raspberry Pi.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote