H3LIS200DL – Triple Axis I2C Accelerometer ±100g/±200g for Arduino

Triple Axis I2C Accelerometer ±100g/±200g for Arduino

Educational STEM Coding & Sensor Starter Packs

  • -40 °C ~ ﹢85 °C
  • ±100g/±200g
  • I2C/SPI
  • 0.5Hz ~ 1KHz
Manufacturer part number
SEN0408
Manufacturer
DFRobot
Operating Temperature
-40 °C ~ ﹢85 °C
Selectable Large Scale Range
±100g/±200g

DFRobot H3LIS200DL triple axis accelerometer with selectable ±100g/±200g scales, for high-speed impact detection and free-fall detection.

Product overview

Overview. The DFRobot Fermion H3LIS200DL is a triple axis accelerometer breakout board built around the H3LIS200DL sensor, designed to measure accelerations with output data rates from 0.5 Hz to 1 kHz. Main characteristics — The measurement scale is selectable between ±100g and ±200g. The device contains two programmable independent interrupt engines able to recognize dedicated inertial events, and a smart sleep to wake-up function allowing advanced power saving. Interfaces and connectivity — The module communicates over I2C, with a default address of 0x19 and a selectable address of 0x18, or over SPI. Power and environment — It operates at 3.3 V, with a current of minimum 10 µA in low-power mode and 0.3 mA to 0.4 mA in normal mode. Its operating temperature range is −40 °C to +85 °C, and it withstands 10000 g high shock. Dimensions: 15 × 20 mm. Typical uses — High-speed impact detection and recording, free-fall detection, and automobile collision testing.

See all specifications

Highlights

  • Dimension: 15*20 (mm) / 0.59*0.79”
  • Fermion: I2C H3LIS200DL Triple Axis Accelerometer (Breakout) (±100g/±200g)
  • Frequency: 0.5Hz ~ 1KHz
  • I2C Address: 0x19 (Default) / 0x18 (Selectable)
  • Interface: I2C/SPI
  • Operating Current: minimum 10uA (low-power mode) / 0.3mA-0.4mA (normal mode)

Good to know before integrating

  • Thermal: rated operating range -40 °C ~ ﹢85 °C — check it against the installation environment.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote