SEN0570 – MEMS smoke detection sensor with 0-5V analog output

MEMS smoke detection sensor with 0-5V analog output

Smoke and Flame Detectors

  • -10°C to 50°C
  • 15-90% RH
  • 13×13×2.5mm
  • <15 seconds
Manufacturer part number
SEN0570
Manufacturer
DFRobot
Operating temperature
-10°C to 50°C
Humidity range
15-90% RH

Compact MEMS smoke sensor DFRobot SEN0570 for qualitative detection of smoke and ethanol from 10 to 1000ppm. Designed for IoT safety systems and industrial monitoring.

Product overview

Overview. The DFRobot SEN0570 is a MEMS smoke sensor supplied as a breakout module, designed for qualitative detection of smoke and ethanol in a range of 10 to 1000ppm. It is a compact sensor intended for IoT safety systems and industrial monitoring.

Main characteristics. The sensor measures 13×13×2.5mm and has a response time of less than 15 seconds. Its sensitivity is specified as R0/Rs ≥3 at 200ppm EtOH. Its lifespan is more than 5 years of continuous use.

Output and power. The output signal is an analog voltage of 0 to 5V. The module operates from 3.3 to 5V DC and draws less than 20mA.

Environmental conditions. The sensor operates between -10°C and 50°C, for a humidity range of 15 to 90% RH.

Typical uses. This sensor suits IoT smoke alarm systems, industrial equipment overheating detection, kitchen safety monitoring, laboratory safety equipment and smart home ventilation control.

Integration. As measurements are qualitative only, the sensor does not provide a precise concentration. For quantitative measurements, the manufacturer points to its Gravity factory-calibrated electrochemical gas sensor series. Remove the protective film before use, and avoid volatile silicon compound vapors, corrosive gases such as H2S, SOX, Cl2 or HCl, and contact with water or condensation. The manufacturer recommends preheating the module for at least 24 hours after extended non-use. This module is not intended for systems involving personal safety.

See all specifications

Highlights

  • Dimensions: 13×13×2.5mm
  • Response time: <15 seconds
  • Humidity range: 15-90% RH
  • Operating temperature: -10°C to 50°C
  • Detection range: 10-1000ppm (qualitative)
  • Lifespan: 5+ years continuous use

Good to know before integrating

  • Thermal: rated operating range -10°C to 50°C — check it against the installation environment.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote