FP01 – Offline Face and Palm Vein Recognition Sensor

Offline Face and Palm Vein Recognition Sensor

Educational STEM Coding & Sensor Starter Packs

  • -20°C~50°C
  • UART, USB
  • 3.3V
  • 400mA
Manufacturer part number
SEN0736
Manufacturer
DFRobot
Operating Temperature
-20°C~50°C
Communication interface
UART, USB

DFRobot FP01 AI vision sensor for contactless biometric authentication by face and palm vein recognition, with onboard processing and local template storage.

Product overview

FP01 from DFRobot. offline face and palm vein recognition sensor. The DFRobot FP01 AI vision sensor performs face, palm vein and palmprint recognition locally, without biometric algorithm SDKs to deploy on the host.

Biometric capabilities. Local storage of 500 facial templates (ID 1 to 500) and 300 palm prints (ID 501 to 800). 3D liveness detection to resist photographs, screen-based video and 3D masks. Cold start recognition speed of 240 ms or less.

Performance. False acceptance rate (FAR) of 0.001% or less and false rejection rate (FRR) below 0.1%. Enrollment distance of 30 to 60 cm for faces and 15 to 20 cm for vein and palm prints, recognition distance of 20 to 90 cm for faces and 10 to 20 cm for vein and palm prints. Face recognition angle of approximately 20 degrees.

Infrared imaging. Capture in complete darkness at 0 Lux, in low-light environments and outdoors without direct sunlight.

Interfaces and connectivity. UART communication at 115200 bps to provide recognition status and ID results to the embedded system. USB interface supporting UVC and UAC protocols and MJPEG video streaming.

Power and environment. Power supply voltage of 3.3 V, operating current of 400 mA and standby current of 175 mA. Operating temperature of -20 °C to 50 °C, operating humidity below 95%. Storage temperature of -40 °C to 70 °C. Aluminum alloy casing, dimensions 21 x 7.2 mm, mounting hole diameter 19 mm.

Typical uses. Embedded authentication and contactless biometric access control, with integration through the UART port for handling identification results.

See all specifications

Highlights

  • Dimensions: 21x7.2mm, Mounting Hole Diameter 19mm
  • Embedded storage: 500 faces (ID 1-500), 300 palm prints (ID 501-800)
  • Casing material: Aluminum Alloy
  • Cold start recognition speed: ≤240ms
  • Communication Baud Rate (UART): 115200bps
  • Communication interface: UART, USB

Good to know before integrating

  • Thermal: rated operating range -20°C~50°C — check it against the installation environment.
  • Power: plan for a supply compatible with 3.3V.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote