QSD6537 – RS485 Modbus open channel Doppler ultrasonic flow meter

RS485 Modbus open channel Doppler ultrasonic flow meter

Ultrasonic Flow Meters

  • 0°C ~+60°C
  • 0°C to 60°C
  • 0mm to 10000mm (10m)
  • 20mm to 5000mm (5m)
Manufacturer part number
QSD6537
Manufacturer
Lanry
Operating Temperature
0°C ~+60°C
Temperature range
0°C to 60°C

Lanry QSD6537 Doppler ultrasonic sensor measuring water velocity, depth and conductivity in rivers, open channels and partially filled pipes, with RS485 Modbus RTU output.

Product overview

Lanry QSD6537. Doppler ultrasonic open channel flow meter sensor designed to measure water flow velocity, depth and electrical conductivity in rivers, streams, open channels and partially filled pipes.

Measurement principle. Velocity is measured by the ultrasonic Doppler principle in quadrature sampling mode. The instrument transmits ultrasonic energy through its epoxy casing; suspended sediment particles or small gas bubbles reflect part of the signal back to the receiver, which calculates the velocity. The velocity range is 20 mm/s to 12 m/s, bidirectional, with an accuracy of ±1 % of measured velocity.

Depth measurement. Depth is measured by two principles: ultrasonic, from a top-mounted sensor, and pressure, from a bottom-mounted sensor. The range is 20 mm to 5 m for ultrasonic and 0 to 10 m for pressure, with 1 mm resolution and ±1 % of measured value accuracy. The pressure principle suits measurements from the side of a pipe, the ultrasonic principle suits clear open channels.

Conductivity. A four-electrode conductivity sensor, exposed to the water at the top of the instrument, measures from 0 to 200,000 µS/cm, typically ±1 % of measurement. This parameter can be recorded with velocity and depth to analyse water quality.

Main characteristics. Simultaneous measurement of velocity, depth and conductivity, accelerometer tilt sensing (±70° in roll and pitch axes), temperature measured with ±0.5 °C accuracy, 16 GB data storage and a 4.5-inch colour LCD display on the calculator.

Interfaces and connectivity. RS-485 output with Modbus RTU, maximum cable length 500 m, plus pulse output, 4-20 mA output (flow and depth), SDI-12 v1.3 (maximum cable 50 m), datalogger and GPRS.

Power and environment. Calculator powered from 85-265 VAC with a rechargeable battery, sensor rated IP68, operating temperature 0 °C to +60 °C and storage -20 °C to +60 °C. Epoxy-sealed sensor body with Marine Grade 316 stainless steel mounting bracket.

Typical uses and integration. Combined with the Lanry DOF6000 calculator, the set calculates flow rate and total flow, including for a cross section described by up to 20 coordinate points. The RS485 Modbus connection allows integration into a supervision system or PLC. Available on quotation from Atlas Electronics.

See all specifications

Highlights

  • Case Material: ABS
  • Data storage: 16GB
  • Depth (Pressure) — Accuracy:: ± 1 % measured
  • Depth (Pressure) — Range:: 0mm to 10000mm (10m)
  • Depth (Pressure) — Resolution:: 1 mm
  • Depth (Ultrasonic) — Accuracy:: ± 1 % measured

Good to know before integrating

  • Thermal: rated operating range 0°C 〜+60°C water temperature — check it against the installation environment.
  • Thermal: rated operating range 0°C ~+60°C — check it against the installation environment.

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Similar products

All Ultrasonic Flow Meters
Request a quote