RAK4630 – LoRa Mesh Base Board with GNSS and Motion Sensor

LoRa Mesh Base Board with GNSS and Motion Sensor

Microcontroller Development Boards

  • RAK4630(H) 9xx MHz
  • USB, UART1
  • Low power high range
Manufacturer part number
116103
Manufacturer
RAKwireless
Frequency band
RAK4630(H) 9xx MHz
Model
RAK4630

RAKwireless base board for Meshtastic LoRa mesh networks, integrating a pre-flashed RAK4630 module, a GNSS receiver and a motion sensor, with a 1.3-inch OLED display supplied unsoldered.

Product overview

Overview. The RAKwireless WisMesh Base Board RAK19026 is a base board for Meshtastic LoRa mesh networks, reference 116103, to get started with this type of network. It integrates an nRF52840 RAK4630 LoRa module pre-flashed with the Meshtastic firmware, a u-blox ZOE-M8Q location module, an ST LIS3DH motion sensor, two WisBlock Sensor slots and one IO slot.

Main characteristics. The RAK4630 combines a 32-bit ARM Cortex-M4F MCU at 64 MHz with 1 MB Flash and 256 KB RAM, a Semtech SX1262 LoRa transceiver and Bluetooth 5.0. It adheres to Classes A, B and C of LoRaWAN 1.0.3 and supports LoRa point-to-point communication. A user programmable button and an on/off switch that disconnects the battery while still allowing recharge through USB or solar complete the board.

Interfaces and connectivity. The board provides USB, UART1 and UART2 ports, an I2C bus and an SPI bus, together with analog inputs and GPIO pins. LoRa, BLE and GPS antennas and a USB cable are included in the package.

Power and consumption. The average current of the RAK4630 module is 4.42 µA in one-time sleep (10 seconds at 3.3 V), 4.23 µA in LoRaWAN one-time sleep, 3.35 mA in idle mode, 2.22 mA when an RX window is received and 67.8 mA when sending 15 bytes (3.6 V, 1 second, in the RAK5005-O board). The MCU supply voltage ranges from -0.3 to 5.8 V and the LoRa chip supply voltage from -0.5 to 3.9 V.

Typical uses. This board suits the deployment of Meshtastic LoRa mesh networks and LoRaWAN networks, as well as on-board location and motion detection thanks to the GNSS and the LIS3DH sensor.

Integration. This version is supplied with a 1.3-inch OLED display unsoldered, to connect through a pin header. The frequency band of this version is 9xx MHz, with the RAK4630(H) module. Frequencies available by region are EU868, US915, AS923-1/2/3/4, AU915, KR920 and IN865 for the RAK4630(H) module, and CN470 for the RAK4630(L) module.

See all specifications

Highlights

  • Frequency band: RAK4630(H) 9xx MHz
  • Model: RAK4630
  • Product Model: GNSS and Motion Sensor with Unsoldered OLED
  • RAK4630: USB, UART1
  • Semtech SX1262: Low power high range

Typical applications

Derived from the part category, not a compatibility statement.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote