Limited record: this part has neither specifications nor a datasheet in the catalog yet. It is shown for reference and is not indexed.

SoftServo-B24CH – 24-channel PWM servo controller with RS485 and I2C

24-channel PWM servo controller with RS485 and I2C

RF Signal Generators

  • RS-485
Manufacturer part number
B24CH
Manufacturer
Seeed Studio

The Seeed Studio SoftServo-B24CH is a 24-channel PWM servo controller designed to drive PWM-style servo motors via RS485 or I2C.

Product overview

Overview. The Seeed Studio SoftServo-B24CH is a 24-channel PWM signal generator, originally designed to control PWM-style servo motors and compatible with most devices that integrate an RC interface.

Interfaces and connectivity. RS485 and I2C are integrated into a single connector and share the same user register, so the servo controller can be used through either interface at any time. All functions are performed by reading or writing the user register, similar to MCU operation, except for a few special operations described in the corresponding communication protocols. The RS485 baud rate is detected automatically; there is no instruction packet loss up to 28800 bps, and it is recommended to send the sync bytes (0xff 0xff 0xff 0xff) first above 28800 bps.

Main characteristics. All 24 PWM signals are output at the same time, with an actual resolution of up to 1 µs (hardware version V22 or higher). Signal coupling is very low. The PWM-Effective-Width typically ranges from 500 µs to 2500 µs. The cycle, minimum and maximum PWM-Effective-Width can be set flexibly, making the controller compatible with all PWM-style servos. A subdivision algorithm with a maximum value of 250 allows the position and speed of each channel to be controlled separately, which supports dynamic robot control. Any PWM output can be terminated at any time by setting its position value to 251, which is useful for protecting the servo.

Soft-start. Soft-Start mode makes a servo rotate slowly when its current position is unknown, at the cost of a higher current draw over a short time. When controlling several servos, starting them in time-sharing mode is recommended to limit the current.

Typical uses. Control of PWM-style servo motors for robotics, driven from an RS485 bus or an I2C bus.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Similar products

All RF Signal Generators
Request a quote