Limited record: this part has neither specifications nor a datasheet in the catalog yet. It is shown for reference and is not indexed.

AS016 – Motor, stepper and servo expansion board for Raspberry Pi

Motor, stepper and servo expansion board for Raspberry Pi

Educational STEM Coding & Sensor Starter Packs

Manufacturer part number
AS016
Manufacturer
SunFounder

SunFounder AS016 expansion board for Raspberry Pi driving DC motors, stepper motors and servos over the I2C bus, for robotics and prototyping projects.

Product overview

SunFounder AS016, motor, stepper and servo expansion board for Raspberry Pi — the board plugs onto the Raspberry Pi I2C pins and drives up to 4 motors or 2 stepper motors and 4 servos, while leaving the 40 GPIO pins free.

Main characteristics. Driven by a TB6612 motor driver chip and a dedicated 16-channel PWM driver, 12-bit resolution, adjustable PWM frequency up to 1.6 kHz, output configurable as push-pull or open-drain. Current is 1.2 A per channel, with a peak of 3 A for approximately 20 ms.

Interfaces and connectivity. Communication over the I2C bus with two data pins (SDA and SCL), compatible with 5 V logic and usable with Arduino or other development boards. The board has 4 address pins, allowing up to 16 boards to be stacked on the same I2C bus. An infrared receiver is built in for infrared control. The 4-route servo port and the 3P standard connector simplify connecting 5 V servos and LEDs.

Power and dimensions. Single power supply of 5 V to 12 V, chosen according to the voltage required by the motors. Dimensions 65 x 56 x 21 mm.

Typical uses. DIY robots, smart cars, robotic arms and intelligent pan-tilt mounts.

Integration. Supplied with one motor/stepper/servo shield. Available on quotation from Atlas Electronics.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote