C-RTK3 – All-Band RTK GNSS Module with Built-in Electronic Compass

All-Band RTK GNSS Module with Built-in Electronic Compass

RTK GNSS Modules

  • -15 ~ +85 ℃
  • 1 × ANT (BWMCX-KEF)
  • RM3100
  • 672 pcs
Manufacturer part number
C-RTK3
Manufacturer
CUAV
Operating Temperature
-15 ~ +85 ℃
Antenna Port
1 × ANT (BWMCX-KEF)

CUAV C-RTK3 X20P all-band RTK GNSS module combining precise positioning and an RM3100 electronic compass for navigation and control in industrial environments.

Product overview

Overview. The CUAV C-RTK3 X20P is an all-band RTK GNSS module that integrates an X20 RTK receiver, an RM3100 electronic compass and an STM32H5 processor, in a 52 × 48.5 × 16.5 mm housing weighing 30 g excluding antenna and feeder cable.

Positioning performance. RTK accuracy of 0.006 m + 1 ppm horizontal and 0.01 m + 1 ppm vertical, PPP-RTK accuracy below 0.06 m horizontal and 0.10 m vertical, and a maximum update rate of 25 Hz. Convergence time below 7 s in RTK and below 40 s in PPP-RTK.

Satellite coverage. Reception of GPS (L1C/A, L2C, L5), GLONASS, BeiDou (B1I, B1C, B2a, B3I), Galileo (E1, E5a, E6), QZSS and NavIC, with support for SBAS corrections and u-blox PointPerfect.

Interfaces and connectivity. One BWMCX-KEF antenna port, one CAN bus (JST GH 1.25 4P) at 1 Mbit/s in CAN and 8 Mbit/s in CAN FD, DroneCAN/CAN FD protocol, one UART (JST GH 1.25 4P), one USB Type-C port and a configurable PPS output from 0.25 Hz to 10 MHz.

Security. Built-in CW interference detection and spectrum analysis, Galileo OSNMA navigation message authentication, secure boot executing only signed firmware, configuration locking, and active antenna short-circuit and open-circuit detection.

Power and environment. Operating voltage of 4.75 to 5.3 V at 200 mA, operating temperature range of -15 to +85 ℃.

Typical uses. Vehicles, agricultural machinery and industrial robots, which require precise positioning at a high update rate.

Integration. Firmware upgrade supported. Available on quotation from Atlas Electronics.

See all specifications

Highlights

  • Antenna Port: 1 × ANT (BWMCX-KEF)
  • Built-in Electronic Compass: RM3100
  • CAN: 1 × CAN (JST GH 1.25 4P)
  • Firmware: C-RTK 3 M4C
  • Hardware Channel: 672 pcs
  • Linearity: 0.50% within ±200 μT

Typical applications

Derived from the part category, not a compatibility statement.

Good to know before integrating

  • Thermal: rated operating range -15 ~ +85 ℃ — check it against the installation environment.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Similar products

All RTK GNSS Modules
Request a quote