Limited record: this part has neither specifications nor a datasheet in the catalog yet. It is shown for reference and is not indexed.

X1007 – PCIe to Dual 2.5-inch SATA HDD/SSD Expansion Board for Raspberry Pi 5

PCIe to Dual 2.5-inch SATA HDD/SSD Expansion Board for Raspberry Pi 5

Maker, Prototyping, Open-Hardware & Developer Boards

Manufacturer part number
X1007
Manufacturer
Geekworm

The Geekworm X1007 is a PCIe to dual SATA expansion board for 2.5-inch HDDs and SSDs, designed for a Raspberry Pi 5 used for mass storage.

Product overview

Geekworm X1007. PCIe to dual SATA HDD/SSD expansion board for 2.5-inch drives on Raspberry Pi 5, allowing two hard drives or SSDs to be connected to the Raspberry Pi 5 simultaneously.

Main characteristics. Board measuring 164.5 mm x 71.85 mm, mounted on the underside of the Raspberry Pi 5 without requiring a GPIO passthrough, so HATs can still be used alongside it. PCIe x1 connector with 16 pins at 0.5 mm pitch, linked to the board by the supplied 37 mm PCIe FFC cable.

Interfaces and connectivity. Two SATA connectors (7+15 pin), compliant with the Serial ATA 3.0 specification and backward compatible with SATA 2.0 and SATA 1.0, supporting communication speeds of 5.0 Gbit/s, 3.0 Gbit/s and 1.5 Gbit/s, with SATA 6G, 3G and 1.5G drives supported. Compliant with PCI-Express v2.0 and backward compatible with PCI-Express v1.0. Plug-and-play installation and LED indicators for power and drive status.

Power and environment. Power supply of 5 Vdc ±5 %, 3 A or more, delivered by the Raspberry Pi 5 via pogo pins, so that a single source powers the board and the drives. Compatible with the official Raspberry Pi 5 active cooler and with third-party coolers. Supports the HAT+ STANDBY power state, automatically turning off SATA devices when the Pi 5 is powered down.

Typical uses. Mass storage for a home media center or a network-attached storage (NAS) system, for storing and streaming videos, music and digital photos.

Integration. The Raspberry Pi 5, the drives, the cooler and the power adapter are not included. New SATA drives must be partitioned and formatted when first connected. The current firmware does not allow booting from an HDD or SSD connected to this board.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote