Limited record: this part has neither specifications nor a datasheet in the catalog yet. It is shown for reference and is not indexed.

U219 – Sub-GHz and NFC expansion module for Cardputer Adv

Sub-GHz and NFC expansion module for Cardputer Adv

Maker, Prototyping, Open-Hardware & Developer Boards

  • RFID and NFC
Manufacturer part number
U219
Manufacturer
M5Stack

M5Stack expansion module combining a CC1101 sub-GHz transceiver and an ST25R3916 NFC front end, for wireless remote control, identification and IoT prototypes.

Product overview

Overview. The M5Stack U219 is a Cap CC1101 expansion module integrating sub-GHz RF and NFC functions, compatible with Cardputer-Adv and CardputerZero. The module communicates over SPI and suits IoT prototyping.

Sub-GHz radio. The RF section is based on the TI CC1101 transceiver, operating in the 315, 433, 868 and 915 MHz bands. Dual SP3T RF switches and a multi-band matching network allow dynamic band switching on a single RP-SMA antenna. The 2-FSK, 4-FSK, GFSK, MSK, ASK and OOK modulations are supported, with independent 64-byte RF RX and TX FIFOs. Receive sensitivity reaches -99.5 dBm and transmit power is +10 dBm. The stated range at FSK modulation with a 58 kbps air rate is 435 m in the 315 MHz band and 441 m in the 433, 868 and 915 MHz bands.

NFC. The NFC section uses the ST25R3916 chip and supports NFC-A and NFC-B (ISO14443A/B), NFC-F (FeliCa™) and NFC-V (ISO15693) protocols, in reader/writer mode and in card emulation mode for NFC-A and NFC-F. A 512-byte NFC FIFO is included.

Power and connectivity. The module runs on 5 V DC and draws 96 mA with the CC1101 continuously transmitting at maximum power while NFC continuously reads cards. It includes an onboard DC-DC buck converter and a HY2.0-4P Grove connector for sensor module expansion. The antenna connects through an RP-SMA female connector. The kit includes three 108 mm RP-SMA rubber antennas, one per band (315 MHz, 433 MHz, and 868/915 MHz).

Typical uses. Wireless remote control, access-control identification, device communication and IoT prototyping. The module is programmable with Arduino and UiFlow2.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote