RAK5010-M-BG95 – NB-IoT GPS tracker with BLE 5.0 and built-in sensors

NB-IoT GPS tracker with BLE 5.0 and built-in sensors

GPS Asset Trackers

  • 1575.42 MHz
  • 500 mA
  • 10 mA
  • 2 A
Manufacturer part number
410008
Manufacturer
RAKwireless
Frequency Range
1575.42 MHz
Charging current
500 mA

RAKwireless NB-IoT GPS tracker based on the Quectel BG95-M3 module, with GNSS, BLE 5.0 and built-in temperature and humidity sensors, intended for asset location and NB-IoT prototyping.

Product overview

RAKwireless RAK5010-M-BG95. The RAK5010-M-BG95 is an NB-IoT GPS tracker (WisTrio NB-IoT Tracker) integrating a Quectel BG95-M3 module for LTE Cat M1 and NB1 networks, a GNSS receiver and a Nordic nRF52840 chip for Bluetooth Low Energy. Main characteristics — The board measures 41 mm x 38 mm x 16 mm with headers and weighs 30 g. It carries an ARM Cortex-M4 32-bit processor with FPU at 64 MHz, 1 MB of flash memory and 256 KB of RAM. Connectivity — The BG95-M3 module supports LTE Cat M1 (300 Kbps downlink, 375 Kbps uplink) and LTE Cat NB1 (32 Kbps downlink, 70 Kbps uplink), as well as GPRS and EDGE. The GNSS covers GPS, GLONASS, BeiDou, Galileo and QZSS at 1575.42 MHz. The BLE 5.0 section offers data rates of 2, 1, 500 and 125 Kbps, with a receive sensitivity of -95 dBm in BLE 1 Mbps mode and a maximum transmit power of 8 dBm. The LTE and GNSS antennas connect through MHF connectors, and an on-board ceramic antenna serves BLE. The interfaces include I2C, UART, GPIO and ADC. Built-in sensors — The RAK5010-M-BG95 model integrates a temperature and humidity sensor and a 3-axis motion sensor. Power and environment — The board is powered by micro USB or a 3.7 V rechargeable battery, with a 5 V port for solar panel charging. The charging current is 500 mA and the maximum discharge current 2 A. The operating temperature range extends from -35 °C to +75 °C. Typical uses — This tracker suits asset location outdoors and indoors thanks to the combination of GNSS and BLE, and prototyping of applications requiring NB-IoT connectivity. Integration — Application development is supported in the GCC environment. The BG96 and BG95-M3 modules are compatible with the AT command interface, but with custom firmware the cellular connection and GNSS location acquisition cannot run at the same time on the BG95-M3. A compatible emulator kit is required for programming.

See all specifications

Highlights

  • Current consumption: 4.8 mA in Tx, 4.6 mA in Rx, and 1.5 uA in Sleep Mode
  • Antenna Type: PCB
  • BG95-M3_AP READY: P0.30
  • BG95-M3_CTS: P0.11
  • BG95-M3_DTR: P0.26
  • BG95-M3_PSM: P0.03

Typical applications

Derived from the part category, not a compatibility statement.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Similar products

All GPS Asset Trackers
Request a quote