Limited record: this part has neither specifications nor a datasheet in the catalog yet. It is shown for reference and is not indexed.

SoftServo-B10CH – 10-channel PWM servo controller and signal generator

10-channel PWM servo controller and signal generator

RF Signal Generators

  • RS-485
Manufacturer part number
B10CH
Manufacturer
Seeed Studio

Seeed Studio SoftServo-B10CH servo controller, a 10-channel PWM signal generator designed mainly to drive PWM-style servo motors, controllable over RS485 or I2C.

Product overview

Overview. The Seeed Studio SoftServo-B10CH is a 10-channel PWM signal generator, originally designed to control PWM-style servo motors and applicable to most devices integrating an RC interface. It is a servo controller whose functions are accessed by reading and writing its user register, similar to microcontroller operation.

Interfaces and communication. RS485 and I2C are integrated into one connector and share the same user register, so the controller can be used through either interface at any time. The RS485 link detects the baud rate automatically. There is no instruction packet loss up to 28800 bps; above that rate the first instruction packet is discarded, and it is recommended to send the sync bytes (0xff 0xff 0xff 0xff) first when the baud rate exceeds 28800 bps.

PWM signals. The PWM signals of all channels are output at the same time, with an actual resolution of up to 1 µs (hardware version higher than V12). The high-level width, called PWM-Effective-Width, is typically from 500 µs to 2500 µs. The cycle, minimum and maximum PWM-Effective-Width can be set flexibly to make all PWM-style servos compatible. Coupling between signals is very low, so each channel behaves as if generated by separate hardware.

Control functions. A Soft-Start mode makes the servo rotate slowly when its current position is unknown, at the cost of higher current for a short time; starting servos in time-sharing mode is suggested when controlling several of them to limit current. Control is based on a subdivision algorithm with a maximum subdivision value of 250: position and speed of each channel are controlled separately, which supports dynamic robot control. All PWM signals can be terminated at any time by setting the equivalent position value to 251, which protects the servo.

Integration. The module suits integration into robots and servo control systems, using the RS485 or I2C interface to exchange data with a host controller. Power supply characteristics are not included in the data provided and should be confirmed before integration.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Similar products

All RF Signal Generators
Request a quote