Limited record: this part has neither specifications nor a datasheet in the catalog yet. It is shown for reference and is not indexed.

MF5 – Facial recognition access control module

Facial recognition access control module

Maker, Prototyping, Open-Hardware & Developer Boards

Manufacturer part number
MF5
Manufacturer
Sipeed

Sipeed MF5 is a facial recognition access controller for door management, with Wiegand interface and door open signal input.

Product overview

Sipeed MF5. The Sipeed MF5 is a facial recognition access controller, listed in the maker, prototyping and open-hardware developer boards category. It is a finished product, supplied with its original firmware.

Main function. The MF5 is a facial recognition access control system. It operates with a 12 V supply applied to the VIN terminal and a common GND.

Interfaces and connectivity. The MF5 provides a Wiegand interface (D0 signal on IO14 and D1 on IO15, with RETURN), an SPI bus (SCLK, MOSI, MISO and CS) for the Ethernet or card reader interface, and a door open signal input OPEN (IO16, active low) with NO and NC contact outputs.

Programming and firmware. The original firmware does not expose a serial protocol. After flashing a serial protocol firmware, the serial link is available on WGD0 (IO14, RX) and WGD1 (IO15, TX). K210 programming uses ISPRX (IO4) and ISPTX (IO5), with BOOT (IO16) for ISP mode and RST (IO54) for reset.

Signal levels. All signal pins operate at 3.3 V.

Typical use. Door access control by facial recognition, with control of the strike or door through the NO and NC contacts, and integration into an access management system via the Wiegand interface.

Integration. The presence of NO and NC outputs and a door open signal input allows the MF5 to be connected to an electric lock. Connection to an existing control system should be verified according to the protocol used.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote