BMI323 – Compact Low-Power 6DOF IMU Sensor with I2C Interface

Compact Low-Power 6DOF IMU Sensor with I2C Interface

Educational STEM Coding & Sensor Starter Packs

  • I²C
  • 356 μA
  • 720 μA
  • ×2
Manufacturer part number
SEN0693
Manufacturer
DFRobot
Communication interface
I²C
Low Power Current
356 μA

DFRobot Fermion IMU module based on the BMI323, combining a 16-bit 3-axis accelerometer and gyroscope for embedded motion sensing. Suited to battery-powered wearables and compact controllers.

Product overview

Overview. The DFRobot Fermion SEN0693 is a 6DOF IMU sensor breakout (3-axis accelerometer and 3-axis gyroscope) based on the Bosch BMI323, for embedded measurement of acceleration, angular velocity, tilt and vibration. Its PCB measures 16 mm × 16 mm.

Main characteristics. The accelerometer has a 16-bit ADC resolution and measurement ranges of ±2 g, ±4 g, ±8 g and ±16 g, with a sensitivity error of ±0.5% and a zero-g offset of ±50 mg. The gyroscope has a 16-bit ADC resolution and angular rate ranges of ±125, ±250, ±500, ±1000 and ±2000 °/s, with a sensitivity error of ±3% without self-calibration, reduced to ±0.7% after self-calibration, and a zero-rate offset of ±1 °/s.

Interfaces and connectivity. The module communicates over I²C, with addresses 0x69 (default) and 0x68. It provides two programmable interrupt pins and uses an SH1.0-5P connector or 2.54 mm pin header holes. Two 2 mm mounting holes are spaced 11 mm apart.

Power and environment. The module operates from a DC 3.3 V supply. Its current draw is 720 μA in normal operation and 356 μA in Low Power mode.

Typical uses. This sensor suits wearables, compact controllers and battery-powered IoT nodes for motion detection and vibration monitoring. Its I²C interface and interrupt pins allow connection to a microcontroller such as an ESP32.

Integration. The module is a breakout intended for direct integration into a circuit. Unlike the Gravity version, it does not include regulation for a 5 V supply.

See all specifications

Highlights

  • Accelerometer ADC Resolution: 16-bit
  • Accelerometer Measurement Ranges: ±2 g, ±4 g, ±8 g, ±16 g
  • Accelerometer Sensitivity Error: ±0.5%
  • Accelerometer Zero-g Offset: ±50 mg
  • Communication interface: I²C
  • Connector Type: SH1.0-5P connector / 2.54 mm pin header holes

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote