SEN0695 – Compact 9DOF IMU Sensor with I2C, Accelerometer, Gyroscope and Magnetometer

Compact 9DOF IMU Sensor with I2C, Accelerometer, Gyroscope and Magnetometer

Educational STEM Coding & Sensor Starter Packs

  • ±2000 µT
  • I²C
  • 0.37 mA
  • 0.92 mA
Manufacturer part number
SEN0695
Manufacturer
DFRobot
Measurement Range
±2000 µT
Communication interface
I²C

DFRobot SEN0695 9DOF IMU module combining accelerometer, gyroscope and magnetometer on a 24 × 19 mm board, communicating over I2C for motion and heading measurement.

Product overview

DFRobot SEN0695. The SEN0695 Fermion is a compact 9DOF IMU sensor (accelerometer, gyroscope and magnetometer) on a 24 mm × 19 mm printed circuit board, designed to integrate motion and heading measurement into prototypes and embedded products.

Main characteristics. The accelerometer provides 16-bit resolution with ranges of ±2 g, ±4 g, ±8 g and ±16 g. The gyroscope, also 16-bit, covers angular rates of ±125, ±250, ±500, ±1000 and ±2000 °/s. The magnetometer measures a field of ±2000 µT with a resolution of approximately 0.1 µT.

Interfaces and connectivity. The module communicates over an I2C bus and provides an SH1.0-5P connector as well as 2.54 mm pin header holes. It has three programmable interrupt pins. The mounting holes have a diameter of 2 mm and a spacing of 19 mm.

Power and consumption. The module operates at 3.3 V. It draws 0.92 mA in operation and 0.37 mA in low-power mode. Operating modes include normal periodic measurement, triggered forced measurement and low-power sleep standby.

Typical uses. This sensor suits motion and orientation detection in embedded robots, wearable devices and electronic compass prototypes, as well as sensor evaluation.

See all specifications

Highlights

  • Accelerometer ADC Resolution: 16-bit
  • Accelerometer Measurement Ranges: ±2 g, ±4 g, ±8 g, ±16 g
  • Accelerometer Sensitivity Error: ±0.5%
  • Accelerometer Zero-g Offset: ±50 mg
  • Communication interface: I²C
  • Connector Type: SH1.0-5P connector / 2.54 mm pin header holes

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote