Limited record: this part has neither specifications nor a datasheet in the catalog yet. It is shown for reference and is not indexed.

DFR0565 – Digital I2C Signal Isolator with 5 V Isolated Power

Digital I2C Signal Isolator with 5 V Isolated Power

DFRobot Gravity Sensor & Actuator System

Manufacturer part number
DFR0565
Manufacturer
DFRobot

DFRobot digital I2C signal isolator that isolates the I2C bus and supplies isolated 5 V power to sensor modules, preventing interference between sensors.

Product overview

Overview. The DFRobot DFR0565 digital I2C signal isolator isolates the I2C signal and provides isolated power to sensor modules, effectively preventing mutual interference between sensor modules. It is designed for multi-parameter water quality detection systems, where a pH sensor and an electrical conductivity sensor sharing the same power source and measuring in the same container can disturb each other.

Main characteristics. Onboard 5 V isolation power chip, no additional power needed. Controller side supply voltage of 5.0 ± 0.15 V, no-load current of 15 mA (typical), module side output voltage of 5.0 ± 0.15 V and maximum output current of 150 mA. Dimensions of 42 × 32 mm.

Interfaces and connectivity. I2C protocol with high signal level 3.3 V and low level 0 V. PH2.0-4P connector, almost compatible with all DFRobot I2C connector sensors or modules, plug and play, no welding. The module side (isolation side) is isolated from all pins on the controller side (non-isolation side), which must not be short-circuited.

Power and environment. Operating voltage of 5.0 V. The 150 mA maximum output current must not be exceeded by the connected sensor or module. The isolator generates heat normally while working.

Integration. The code of the sensor module in the control board does not need to be modified, which keeps integration simple.

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote