DFR0576 – Digital 1-to-8 I2C Multiplexer

Digital 1-to-8 I2C Multiplexer

DFRobot Gravity Sensor & Actuator System

  • 0x70~0x77
  • high 3.3V, low 0V
  • I2C
  • 100K, 400K
Manufacturer part number
DFR0576
Manufacturer
DFRobot
I2C Address Range
0x70~0x77
Interface Level
high 3.3V, low 0V

The DFRobot DFR0576 is an I2C multiplexer that splits one I2C port into 8 outputs, allowing several sensors sharing the same I2C address to be connected to one controller.

Product overview

Overview. The DFRobot DFR0576 digital 1-to-8 I2C multiplexer is an I2C multiplexer that lets several devices sharing the same I2C address be connected on a single port of the microcontroller. It resolves address conflicts without modifying the sensors themselves.

Main characteristics. It provides 8 I2C ports and a default I2C address of 0x70, adjustable with dial switches over the range 0x70 to 0x77. Supported I2C clock rates are 100K and 400K.

Interfaces and connectivity. The module uses a PH2.0-4P Gravity-type connector, with the I2C interface protocol and logic levels of high 3.3V and low 0V.

Power and dimensions. The operating voltage ranges from 3.3 to 5.0 V. The module measures 32 × 32 mm.

Typical uses. This multiplexer suits connecting several identical I2C sensors to one main board, such as a Raspberry Pi (3.3 V) or an Arduino (5 V).

Integration. The multiplexer can be cascaded on eight addresses (0x70 to 0x77), which, according to the manufacturer, allows control of up to 64 same-address devices. It ships with a Gravity 4-pin UART/I2C cable and a 5-pin XH2.54 header.

See all specifications

Highlights

  • Connector Type: PH2.0-4P
  • Default I2C Address: 0x70 (dial switches all to 0)
  • Dimension: 32*32mm / 1.26*1.26in
  • Gravity: Digital 1-to-8 I2C Multiplexer
  • I2C Address Range: 0x70~0x77
  • I2C Clock Rate: 100K, 400K

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote