SEN0628 – 8×8 Matrix 3D ToF Distance Sensor with 64 Zones

8×8 Matrix 3D ToF Distance Sensor with 64 Zones

DFRobot Gravity Sensor & Actuator System

  • 20mm - 3500mm
  • I2C/UART/USB
  • Less than 80mA
  • RP2040
Manufacturer part number
SEN0628
Manufacturer
DFRobot
Ranging Range
20mm - 3500mm
Data interface
I2C/UART/USB

DFRobot 8×8 matrix ToF distance sensor providing a 64-zone depth map for obstacle detection and zone monitoring. Available on quotation.

Product overview

DFRobot SEN0628 8×8 ToF matrix sensor. The SEN0628 is an 8×8 ToF distance sensor from DFRobot, built around a VL53L7CX ranging sensor and an RP2040 microcontroller that runs the module firmware. It provides a matrix of 64 ranging points instead of a single distance.

Main characteristics. The field of view is 60° horizontal, 60° vertical and 90° diagonal. The ranging range extends from 20 mm to 3500 mm, in continuous ranging mode at 15 Hz to 60 Hz. Between 20 and 200 mm, accuracy is ±11 mm for white targets, ±12 mm for light gray targets and ±12 mm for gray targets.

Interfaces and connectivity. The module offers I2C, UART and USB interfaces. The I2C address is selectable among four options, 0x30, 0x31, 0x32 and 0x33, allowing up to four sensors to be daisy-chained. The UART baud rate is fixed at 115200 bps and cannot be modified. The connector is a PH2.0-4P with Gravity pinout. Firmware is updated via USB Type-C or USB flash drive mode.

Power and environment. The operating voltage is 3.3 V to 5 V, with an operating current below 80 mA. The product complies with Class 1 laser safety standards.

Typical uses. The module suits obstacle detection, zone-change monitoring and interactive projects. It can be programmed with the Arduino IDE, Mind+ or MakeCode.

Integration. Supported platforms include Arduino, micro:bit, ESP32, Raspberry Pi, LattePanda and UNIHIKER K10. The depth map is low-resolution data, not a camera image; recognition and navigation require application logic.

See all specifications

Highlights

  • Algorithm Processing MCU: RP2040
  • Data interface: I2C/UART/USB
  • Firmware Update: TYPE-C, USB flash drive mode
  • I2C Address: 4 adjustable options: 0x30/0x31/0x32/0x33
  • Interface Type: PH2.0-4P (Gravity Pinout)
  • Laser Safety Class: Compliant with Class 1 laser safety standards

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote