BMI323 – 6-axis IMU sensor accelerometer and gyroscope I2C/UART

6-axis IMU sensor accelerometer and gyroscope I2C/UART

DFRobot Gravity Sensor & Actuator System

  • I²C / UART
  • 3.1 mA
  • ×2
  • 16-bit
Manufacturer part number
SEN0692
Manufacturer
DFRobot
Communication interface
I²C / UART
Operating Current
3.1 mA

DFRobot Gravity 6DOF inertial sensor combining an accelerometer and a gyroscope to measure acceleration, angular rate, tilt and motion. Intended for fast prototyping on Arduino, ESP32 and Raspberry Pi.

Product overview

Overview. The DFRobot SEN0692 is a 6DOF IMU sensor, a plug-and-play Gravity module built around the Bosch BMI323, which combines a 3-axis accelerometer and a 3-axis gyroscope to measure linear acceleration, angular velocity, tilt and motion changes.

Main characteristics. 16-bit ADC resolution, accelerometer ranges of ±2 g, ±4 g, ±8 g and ±16 g, gyroscope ranges of ±125, ±250, ±500, ±1000 and ±2000 °/s, zero-g offset of ±50 mg, zero-rate offset of ±1 °/s and sensitivity error of ±0.5%.

Interfaces and connectivity. I²C or UART communication, with four selectable I²C addresses (0x4A default, 0x4B, 0x4C, 0x4D), PH2.0-4P connector with Gravity pinout and 2.54 mm pin header holes, and two programmable interrupt pins.

Power and environment. Operating voltage of DC 3.3–5 V, operating current of 3.1 mA. Four operating modes (Sleep, Low Power, Normal, High Performance) allow power consumption to be selected on demand.

Typical uses. Motion, gesture and tilt detection, integration in projects based on microcontrollers or Raspberry Pi boards, supported by a dedicated DFRobot library.

Integration. The module connects directly to Arduino, ESP32 and Raspberry Pi boards through the Gravity connector, without soldering. Available on quotation from Atlas Electronics.

See all specifications

Highlights

  • ADC Resolution: 16-bit
  • Angular Rate Ranges: ±125, ±250, ±500, ±1000, ±2000 °/s
  • Communication interface: I²C / UART
  • Connector Type: PH2.0-4P (Gravity pinout) / 2.54 mm pin header holes
  • I²C Addresses: 0x4A (default) / 0x4B / 0x4C / 0x4D
  • Measurement Ranges: ±2 g, ±4 g, ±8 g, ±16 g

See also

Technical questions

Ask a question

No published question about this part yet. Questions are reviewed before publication.

Request a quote